4) You will need to have on hand water heater tape, small gas torch, solder, flux, plumbing sandpaper, pipe cutter, gas tape (to seal gas line) and maybe some pipe glue. Ask the sales person at the hardware store for a more defined list.
49. If you get lost at night water line repair stop and gain time to sort out the problem. Motor into wind or tide so there is the least amount of speed over the ground. This gives the navigator a better chance of gathering his thoughts.
A c clamp or hose clamp is use full for securing or holding the rubber used to seal leaks on piping. However, a clamp should be used carefully considering the type of pipe being repaired, clamping too tight will fracture the pie leaving you with a bigger problem than you started off with.
Working on the gas lines is also a complex job that only a licensed plumber can handle because it is very dangerous. Small leaks can't always be detected by odor alone, but a licensed professional has the proper equipment that's needed to ensure that you don't have any leaks in the line.
One tip is to avoid hiring a plumber, who is a part or who is representing a company. They usually work on a commission basis. The company usually has a flat rate for every plumbing service and the plumber's commission will be added up to the company's charge. This is one of the main reasons why some plumbers charge you with a ridiculously high amount of money for their services. Opt for freelance water line repair plumbers instead. They work for themselves, so the price is usually negotiable.
The way a toilet plunger works is by filling up with water and then pushing that water through the stopped up drain. When unclogging a clogged toilet, the idea is to plunge up and down a couple of times so the plunger fills with water and then jam the open end, sometimes called a force cone, into the waste outlet in the plugged toilet and start plunging. You may have to pump the plunger up and down several times to clear the blockage.
Then, you can take your new shower parts home and reinstall them in the inner assembly. It is very important that everything be aligned properly and tightened to prevent leaks. Beware of over tightening, however, since this can also cause problems. Once you are sure everything is installed properly, replace the cover plate and turn the water back on to test your repair work. With a little bit of work, your do-it-yourself shower repair project can be a success. It does not take an expert, just a little effort and know how.